AEG Washer Dryer not drying, washes correctly.
The Heating element checks out as being O.K.
The Duct fan runs at start of drying sequence and remains running until the end of drying sequence.
240v appears at Heating Element terminals shortly after Duct Fan starts, but stays 'live' for about 10 seconds.
There is an over-temperature sensor mounted by the Heating Element, this checks out (Closed Circuit).
There are two other sensors, one towards the air intake and one further towards the back of the machine, near the Duct Fan (presume these are NTC Thermistors).
I get a resistance reading when checking these out, could one or both of these thermistors be defective?
Machine does not display a Fault Code. (Do you need to press Control Buttons to get Fault Code to display)? If so which button(s)?
The Heating element checks out as being O.K.
The Duct fan runs at start of drying sequence and remains running until the end of drying sequence.
240v appears at Heating Element terminals shortly after Duct Fan starts, but stays 'live' for about 10 seconds.
There is an over-temperature sensor mounted by the Heating Element, this checks out (Closed Circuit).
There are two other sensors, one towards the air intake and one further towards the back of the machine, near the Duct Fan (presume these are NTC Thermistors).
I get a resistance reading when checking these out, could one or both of these thermistors be defective?
Machine does not display a Fault Code. (Do you need to press Control Buttons to get Fault Code to display)? If so which button(s)?