Domestic Appliance Forum
Amana Washing Machine Error/Fault Codes
“Sd” – (Excess suds)
F8 followed by E1 – (water supply error)
F9 followed by E1 – (drain pump system error)
F5 followed by E2 – (door will not lock)
F7 followed by E1 – (motor drive error)
“rL” – (remove load)
Washer making error beeps – Door has not been opened and closed for at least 3 cycles
Washer beeps when HOLD TO START is touched – Door not closed
F# E# code other than as described above appears in display – System Code Error
“nt” (interrupted) – Cycle was paused or cancelled
Clean Washer LED flashing at end of wash cycle – The washer has run 30 wash cycles and is indicating a reminder to run the Clean Washer cycle
“Sd” – (Excess suds)
F8 followed by E1 – (water supply error)
F9 followed by E1 – (drain pump system error)
F5 followed by E2 – (door will not lock)
F7 followed by E1 – (motor drive error)
“rL” – (remove load)
Washer making error beeps – Door has not been opened and closed for at least 3 cycles
Washer beeps when HOLD TO START is touched – Door not closed
F# E# code other than as described above appears in display – System Code Error
“nt” (interrupted) – Cycle was paused or cancelled
Clean Washer LED flashing at end of wash cycle – The washer has run 30 wash cycles and is indicating a reminder to run the Clean Washer cycle
- Page :
- 1
There are no replies made for this post yet.