AEG Washer Dryer (L7WEG841R)
Washer not drying, washes correctly.
The Heating Element checks out correctly.
Dryer Duct Fan starts at the beginning of the Drying Sequence and continues to run until the end of the drying sequence.
240 volts appears at the terminals of the Heating Element shortly after the Duct Fan starts but only stays ‘live’ for about 10 seconds.
There is an over-temperature sensor (trip) mounted near to The Heating Element, this checks out (Closed Circuit).
There are two other sensors mounted on the Fan Duct, one towards the front of the machine and a second one towards the back of the machine mounted near the Duct Fan (presume these are NTC Thermistors)
I get a resistance reading when checking these with an Ohmmeter.
Could one or both of these sensors be defective?
The machine does not display a Fault Code. (Do you need to press Control Button(s) in order to display Fault Codes)?
If so, which Button(s)
Washer not drying, washes correctly.
The Heating Element checks out correctly.
Dryer Duct Fan starts at the beginning of the Drying Sequence and continues to run until the end of the drying sequence.
240 volts appears at the terminals of the Heating Element shortly after the Duct Fan starts but only stays ‘live’ for about 10 seconds.
There is an over-temperature sensor (trip) mounted near to The Heating Element, this checks out (Closed Circuit).
There are two other sensors mounted on the Fan Duct, one towards the front of the machine and a second one towards the back of the machine mounted near the Duct Fan (presume these are NTC Thermistors)
I get a resistance reading when checking these with an Ohmmeter.
Could one or both of these sensors be defective?
The machine does not display a Fault Code. (Do you need to press Control Button(s) in order to display Fault Codes)?
If so, which Button(s)